Dyna-fit suspenders have no mid-back hardware.

Float is accomplished through an interplay of the suspender loop. The quick adjust mechanism allows a snug fit after easy donning by simply pulling on the attached ring.
 

• Quick Adjust: A snug fit after easy donning, no need to duck shoulders
• Optional Reflective Trim: Two tone reflective 3M Scotchlite material
• Rig Friendly Non-Button suspender snaps
• Blue/Red Straps

“Rig friendly” non-button suspender snap attachments are the ONLY suspender system that coordinate with Structural TAC pants (suspender buttons would be very uncomfortable when the system was reversed) and with EMS and Technical Rescue and Recovery pants (where users have asked us to avoid metal use whenever possible due to sparking concerns).

This tabbed system is becoming increasingly popular since it prevents suspender “rotation” when pants are being donned.

Short under 40"

• Suspender Sizing: Measuring should be done when wearing bunker pants. Measure from between the left front suspender buttons, up and over the left shoulder, then down and across the back to between the right rear suspender buttons. 40 or less, order short. From 41 to 45 order regular. From 46 to 50 order long.