6" Female NH to 4" Rocker Lug Jumbo Short Ball Intake Valve

AP series jumbo small intake valve has a huge 5¼ inch diameter waterway minimizing low friction loss and maximizing flow. Friction loss is 3psi at 2000gpm. Designed for use with 5 inch (125mm) hose on a pressure or vacuum service pumper. Maximum operating pressure is 300psi (20bar) and meets the 900psi (62bar) hydrostatic strength test. Aluminum castings are hardcoat anodized with a powder coat finish inside and out for maximum corrosion protection. All components on the wet side of the valve are made of stainless steel for additional corrosion protection. The hand wheel needs 7½ turns to close, meeting NFPA slow close requirements. There is a unique position indicator that shows the operator if the valve is open, closed or somewhere in between. The standard gearbox handwheel is installed by the factory on the right side but can be switched to the left side if desired. Comes equipped with a rugged ¾ inch (19mm) drain valve to quickly drain water from the valve housing. A port for an optional air bleed valve is incorporated into the design for user friendly configuration. Hose coupling and truck connectors are attached to the valve using polymer bearing rings that provide electrical isolation to help prevent galvanic corrosion. Includes an adjustable pressure relief valve with a discharge that can be direction one of four ways and meets NFPA 1901 (2009 edition).
 

AP7NP-	NX-PS
Weight:	30 lbs (13.6kg)
Water Flow Style:	Valve
Waterway Size:	5.25 inch (133.35mm)
Valve Actuation Method:	Crank
Valve Design:	Ball valve (stainless)
Coupling Size Side A:	6 inch (150mm)
Coupling Style Side A:	Handle
Coupling Swivel/Rigid Side A:	Swivel (non full time, no swivel after tightening)
Coupling Size Side B:	4 inch (100mm)
Coupling Style Side B:	Rocker Lug
Coupling Swiveling/Rigid Side B:	Swivel (non full time, no swivel after tightening)
Pressure Relief Valve:	Yes
Finish:	Powder coated
Gearbox Style:	Shaft on Top
Operation Energy Source:	Manual