6" Rigid Storz to 5" Rigid Storz Jumbo Short Ball Intake Valve

AP series jumbo small intake valve has a huge 5.25 inch diameter waterway minimizing low friction loss and maximizing flow. Friction loss is 3psi at 2000gpm.

Designed for use with 5 inch (125mm hose on a pressure or vacuum service pumper. Maximum operating pressure is 300psi (20bar) and meets the 900psi (62bar) hydrostatic strength test.

Aluminum castings are hardcoat anodized with a powder coat finish inside and out for maximum corrosion protection. All components on the wet side of the valve are made of stainless steel for additional corrosion protection.

The hand wheel needs 7.5 turns to close, meeting NFPA slow close requirements. There is a unique position indicator that shows the operator if the valve is open, closed or somewhere in between. The standard gearbox handwheel is installed by the factory on the right side but can be switched to the left side if desired.

Comes equipped with a rugged .75 inch (19mm) drain valve to quickly drain water from the valve housing. A port for an optional air bleed valve is incorporated into the design for user friendly configuration.

Hose coupling and truck connectors are attached to the valve using polymer bearing rings that provide electrical isolation to help prevent galvanic corrosion.

Includes an adjustable pressure relief valve with a discharge that can be direction one of four ways and meets NFPA 1901 (2009 edition).

Features

• Water Flow Style: Valve
• Waterway Size: 5.25" | 133.35mm
• Valve Design: Stainless Ball valve
• Side A Coupling Size: 6" | 150mm
• Side A Coupling Style: Handle
• Side A Coupling Swivel/Rigid: Non full time Swivel, no swivel after tightening
• Side B Coupling Size: 5" | 125mm
• Side B Coupling Style: Storz
• Side B Coupling Swivel/Rigid: Rigid
• Pressure Relief Valve: Yes
• Finish: Powder Coated

 

AP1ST-	NX	NX-PS	NX-RC
Weight:	30 lbs (13.6kg)	30 lbs (13.6kg)	30 lbs (13.6kg)
Valve Actuation Method:	Hand wheel (6 inch, injection molded nylon)	Crank	Handwheel (3 inch, injection molded nylon)
Gearbox Style:	Shaft on side	Shaft on Top	Shaft on side
Operation Energy Source:	Manual	Manual	Electrical